Our Products

 Click Here for Air Horns & Air Kits

Click Here VIAIR On Board Systems

Click Here AirLIFT Air Suspensions

Click Here for 100% Stainless Exhaust Tips

Click Here for High Performance Catalytic Converters

Click Here for Billet Aluminum Fuel Doors

Click Here for Race Performance Gauges

 

2009 Porsche Cayenne GTS-Air Horn System Installed

Jon H. from Virginia sent us some pics and info of his 2009 Porsche Cayenne GTS six speed with an Assured Performance Horn and Viair Air System

Jon purchase our 140db Dual Trumpet Truck Air Horn Kit with the Viair 400c Compressor and 2.5 gallon Tank Kit.

The truck horns went in behind front Right fender liner without much problem.

Left side was too crowded to use.

As you can see the horns are facing forward for the ultimate sound.

The Viair Tank, pump and controls went into Left Rear Quarter panel storage area.

We ran 40A line from battery, and relay current from the 12v outlet in photo. Controlled by steering wheel Horn button.

The pump is quite loud attached to the inner fender, but is ON so seldom that it is not a problem.

We needed additional hi pressure hose, so used some 150# truck brake line hose. It is more pliable and easier to install.

The kit was complete and the instructions were excellent. Installation took 12 hours.

It is of course VERY loud. The only thing I would change is someday perhaps to a lower note. I am looking for ‘Ocean Liner’ sound.

“Highly recommended. Thanks”

Assured Automotive Company Thanks Jon for the pics and info!!

Gloss Black Exhaust Tip – 2000 BMW 323i

Josh F. sent us pictures of the new Assured Performance “Black Powder” exhaust tip on his 2000 BMW 323i 2.5L. I-6.    The tip he purchased for his project was part number AC079-BKG.

The tip was purchased from Assured Automotive Company.

Assured Performance Exhaust Tip AC079-BKG is a dual outlet with the outside dimensions of the outlet measuring 3 inches tall and 7.4 inches wide.  The length is 9.5 inches.  The inlet inside diameter is 2.5 inches.

Judging by the under carriage picture Josh sent us, no modifications were needed for install.

Josh had the exhaust tip welded on and it looks like he did a little bit of trimming on rear valance.  Trimming is sometimes required to allow clearance of the exhaust tip exiting the back of the vehicle

Looks Great Josh!!

Thank you for the pictures!!